Liquid Rubber Daclar™.
Liquid Rubber Daclar™ is a modified elastomeric asphalt emulsion specifically formulated as a spray applied roof coating. Liquid Rubber Daclar™ is part of a dual component system that is applied using a specifically designed spray applicator.
The technology advances in Liquid Rubber Daclar™ give a quick setting coating membrane that is solvent free and has excellent strength, elasticity and adhesion.
Liquid Rubber Daclar™ is an environmentally friendly roofing product which can be applied indoors and outdoors with no specialized protective equipment.
USES
Liquid Rubber Daclar™ is used as a waterproofing membrane for roof protection. Liquid Rubber Daclar™ can be applied over a wide range of substrates including existing BUR, polyethylene, membranes and shingles.
APPLICATION
Liquid Rubber Daclar™ is applied as a dual component system using a specially designed spray system. Both components of this system are water based and environmentally friendly. Applied at ambient temperature (above 5°C) Liquid Rubber Daclar™ sets almost instantly, forming a seamless flexible membrane. Liquid Rubber Daclar™ is a safe alternative to conventional hot-applied or solvent based roofing systems.
Liquid Rubber Daclar™ should be applied to a dry surface which is free of dirt, debris, oil or grease. The product sets up rapidly, however it is not recommended to apply any roofing product if heavy rains are imminent. For best results apply in thin coats. With joints or cracks in the surface it is recommended that fabric reinforcing be used. In some cases initial ‘flood coating’ with one component may be recommended. See application manual or consult with your Liquid Rubber Engineered Coatings representative for further details.
Liquid Rubber Daclar™ is to be applied between 0.3-0.6 m2/liter (15-30 ft2/gal) to produce a 40 mil protective membrane to 0.175 m2/liter (7.5 ft2/gal) to produce a 160 mil membrane. Liquid Rubber Daclar™ will be dry to the touch in one minute @20°C and is largely cured within 48 hrs. Final cured properties may, however, not be realized for 28 days.
Typically an applicator crew can spray greater than 6,000 ft2 (550 m2) per day. Protection board or insulation may be applied to the membrane surface after an initial set time of 20 minutes.
Additional Information
Adobe Acrobat Reader is required to view the above PDF files. This is a free program available from the Adobe web site. Follow the download directions on the Adobe web site to get your copy of Adobe Acrobat Reader.


